Gobel Power After-Sales Center

Same with JLD-BMS-S16A150-4P4L-V1.06-01-H-20231212.

Hi, the RS150 can be equipped with a heating pad. I would like to understand how the controls works. I can't find any information about it in the operating instructions. my guess: -turn on heater when temperature <= UTA alarm, -turn off heater when temperature >= UTA recovery, Are there other parame...

Try both versions of BMS-Tools from https://drive.google.com/drive/folders/ ... v_rYF5-Rg3
Gobel_RN_BMS_Tools_FC_1.01.02_17(32bit) --> PWD 123456
Gobel_RN_BMS_Tools_1.01.02_11(32bit) --> PWD 127602

Hi again. Update to V1.06-01-H-20231212 is done. The voltage between Cerbo BSLBATT details lowest/highest cell voltage and RN_BMS_Tools software match. But the battery BMS display showes different cell voltage only on lowest/highest cells. It seems like the values of the other cells match. I have an...

OK. Thank you.
Does it make sense to update to the new V1.06-01-H-20231212 firmware? I am still using the first one JLD-BMS-S16A150-4P4L-V0.00.05_2 firmware (Not available in the gobel download area)? I am a little surprised about my V0. ... version.

I use DVCC and Limit Voltage to 54,4V. Works fine. No flapping an battery reaches 100% SOC.

Hello, i own 2 GP-SR1-RN150 connected to Victron Cerbo over CAN. The System is working fine. But the cell voltage displayed on the battery and in cerbo do not match. Example (@50% SOC): BMS monitor -- Cerbo BSLBATT details Lowest cell voltage Cell10: 3390mV -- 01::10 3.364V --> Δ 0,026V BMS monitor ...

The 5A Active Balancer seems to be always active. This may lead to an imbalancing of the cells in the mid voltage range of the cells because the SOC-U-characteristic is very flat there and even small tolerances in the voltage measurement or the cells itself might have a negative effect. Because of ...